V-Tec 2-wire User Manual download pdf (Page 10)

RPM's, but this is quite normal.

5) Take your car out ona test run.

During this time, check for any "check engine" lights, and make sure that the

engine is running smoothly.

●

The default setting for the VTEC / MIVEC switch-over point is at 4500 RPM.●

6) After your test run,turn off your engine and turn your ignition to the OFF position

Confirm that there is no power going to the SFC-VTEC unit.

●

The SFC-VTEC will stay on for several seconds after turning the ignition to OFF,

but this is normal.

●

Switching between modes

Switch Definitions

Short Hold - ( < 0.5 seconds )

Long Hold - ( 0.5 ~ 2.0 seconds )

Continued Hold- ( > 2.0 seconds )

1) While in "Realtime Mode," give the MODE button a

long hold.

You should hear an electronic "beeep," indicating that

the mode has changed.

Once you hear the sound and the mode changes, please

let go of the MODE button. If you continue to press it,

the SFC-VTEC will turn off.

2) Repeating the instructions from above, one can

switch from SFC to VTC to SPD mode.

SFC - SFC Mode

VTC - VTEC Mode

SPD - Speedometer

* - changing between modes can only be done during

"Realtime Mode"

Steps to properly testing your unit

http://asia.vtec.net/beystock/field/sfc-vtec/x01_sfcv004.html (2 von 2) [06.07.2000 22:47:22]

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 34 35

No comments

V-Tec 2-wire User Manual Page 10